Tool t92p 70010 ah

Policy Documents. Our Privacy Policy has been updated. Please review the updated Privacy Policy and accept changes. If you have any questions please send your concerns to the address available in contact section in the Privacy Policy. Click here to accept the Privacy Policy. Please review the updated Terms and Conditions of Use and accept changes. Click here to accept Terms and Conditions of Use.

Please review the updated Terms and Conditions of Sale and accept changes. Click here to accept Terms and Conditions of Sale. Click "Accept" to proceed or click "Cancel" to close the web page. View Content As :. My Wish List My Preferences. Search Tips. Item may not be exactly as pictured. Alignment Gauge, TR Sensor. Insert a scratch awl into the access hole located in the bottom of the lower steering column shroud.

Push in on the ignition lock cylinder release pin and rotate the ignition lock cylinder clockwise to the RUN position and remove the ignition lock cylinder from the steering column tube.

Tighten screws to 2 N-m 17 lb-in. Raise steering column tube into position and secure with two nuts. Tighten nuts to N-m lb-ft. Install steering column absorber and secure with two nuts. Place lower steering column shroud into position and insert ignition lock cylinder into steering column tube. The ignition key should be removable only with the transaxle range selector lever in PARK.

The transaxle range selector lever should be locked in the PARK position with the key removed. Disconnect transmission shift cable from transaxle range selector lever and transaxle range selector lever housing.

Dislodge transmission shift cable grommet from dash panel and gently pull transmission shift cable through dash panel from engine compartment side being careful not to pull mechanics wire completely through dash panel.

Install shift cable bracket to transaxle and secure with two bolts and one nut. Tighten bolts and nut to N-m lb-ft. Attach mechanic's wire to shift selector lever end of shift cable and thread opposite end of mechanics wire through dash panel and into passenger compartment. Gently pull shift cable through dash panel and into passenger compartment side until shift cable grommet can be seated into dash panel. Connect shift cable to manual control lever and secure with shift cable-to-manual control lever nut.

Do not tighten nut until shift cable has been adjusted. Adjust shift cable.